Please use this identifier to cite or link to this item: http://dspace.dtu.ac.in:8080/jspui/handle/repository/15404
Title: SIMULATION AND ANALYSIS OF PENTACENE BASED FIELD EFFECT TRANSISTOR
Authors: NISHANT
Keywords: FIELD EFFECT TRANSISTOR
SIMULATION
ANALYSIS OF PENTACENE
Issue Date: Jun-2014
Series/Report no.: TD NO.1502;
Abstract: This study represents the variation in contact length in top contact OFET geometry and channel length variation in bottom contact OFET geometry, software simulations were performed on ATLAS and observed the Id-Vg characteristics .Higher contact length reduces contact resistance but large contacts greatly increase the device size and consume more contact material. Parameters use in the structure of the OFET are length of the device is 90 micro meter. Width of the gate is 20 nano meter and material used is aluminium, width of the gate oxide is 300 nano meter material used is SiO2, organic material is pentacene thickness of pentacene is 100 nano meter, source and drain thickness is 20 nano meter length is varied over 10 micro meter to 40 micro meter in bottom contact and 10micro meter to 30 microm in top contact geometry. Both the case top contact and bottom contact the parameters are same. As shown in the figure that increasing the contact length the value of drain current is increased. Drain current increases with increasing the contact length but in contact length 10μm and less drain current value is very low. Therefore contact length is greater than 10μm. Best suitable contact length for top contact geometry is 30μm. In bottom contact the variation in channel length 10μm and 20μm shows abnormal characteristic because in bottom contact the charge injection area is near the contact current crowding is more if channel length is small. Best suitable channel length for bottom contact is 30μm. Lc is the length of the source and Lco is the characteristic length Rs is the source resistance Rch is channel resistance. The influences of the contact length (LC) on the contact resistance (Rsd = Rs + Rd) and the channel resistance (Rch) . At a small VG , Rsd decreases slightly upon expanding LC whereas more than 60% decrease in Rsd can be obtained at high VG.Over the critical length LC0=0.6μm,further expanding increases the parasitic capacitance that will adversely affect the performance. In OFET organic semiconductor used in the simulation is pentacene which is a p-type semiconductor. It works in the accumulation mode. When gate voltage and drain voltage is applied. This simulation is done with ATLAS. ATLAS is simulation software. In this project work variation in the contact length is observed. How small contact can be obtained. Contact material used in OFET is Au. So to reduce the cost contact must reduce.
URI: http://dspace.dtu.ac.in:8080/jspui/handle/repository/15404
Appears in Collections:M.E./M.Tech. Applied Physics

Files in This Item:
File Description SizeFormat 
STARTING PAGES.pdf379.54 kBAdobe PDFView/Open
Dissertation Nishant Mtech Dtu.pdf856.52 kBAdobe PDFView/Open


Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.